Products › Workshop & Metalworking
Sheet Metal Edge Bender
Dual-station roller bender for flashing, trim and roofing panels.
A portable two-station roller bender that forms clean 0 to 100 degree edges on thin sheet metal. Built for roofers, HVAC installers and fabricators who need accurate bends on site without hauling a bench brake.
Features
- ✓Bends 0 to 100 degrees. Forms flashing, drip edge, trim and roofing panels through a full 0 to 100 degree range. The height scale is set once and repeats across the whole run.
- ✓Two roller stations. Switch between edge forming and panel work without re-setting the tool, so a job with two bend profiles stays one setup.
- ✓Works where the panel is. Light enough to carry up a ladder, which keeps on-site repairs and trim fitting off the bench brake and out of a second trip.
- ✓Straight across the width. Hardened rollers in a rigid frame hold the bend line true, so panels meet without a gap at the seam.
- ✓For roofers, HVAC installers and fabricators. Sized for the kind of thin-gauge work that does not justify hauling a stationary brake to site.
Own this product? Register for a free lifetime warranty.
If your product ever fails because of a defect, we replace it or refund you in full. Takes under a minute.
Register my warrantyASIN B0GFP5BF41 · B0GKDNT6CB · B0HBPLP5TD
More in Workshop & Metalworking
Workshop & Metalworking
Sheet Metal Edge Bender with Carry Handle
The same 7-inch two-station bender, with an integrated top handle.
Workshop & Metalworking
300 lb Bar Clamp Set, 6-Pack
Four 6-inch and two 12-inch quick-grip clamps with 2.75-inch reach.
Workshop & Metalworking
Stainless Steel Doweling Jig Kit
Three fixed drill guides, an adjustable 90 degree base and indexing pins.
Workshop & Metalworking
Precision Box Joint Jig
Router-table finger joint jig with aluminum indexing keys.